Piaa 2100 Series Uživatelský manuál stáhnout pdf

Thank you very much for purchasing PIAA product.

Please read this entire manual before installation and use of this product.

Installation Instructions

2100X

Please give this Installation Manual to customer after installing.

For Installers

• Lighting laws vary state to state, check your

local laws before use.

• The lamps get very hot when they have been in use.

Do not touch them as they may cause burns.

• After the lights have been on do not place them near

flammable objects.

• Do not splash water directly on the hot lamps, as this may cause cracking of the

lens due to dramatic change in temperature.

• Do not look directly into the light of the lamps as the bright light may

cause eye damage.

• This light system may be used only as high beam auxiliary lighting.

• The lamps and relay harness are to be used only with 12 volt automotive

electrical systems.

• Using this light system while the engine is not running will drain the battery.

• Do not repeatedly turn the light system on and off as it will shorten the life

of the system.

• Some automobiles generate high voltage at start up and when it is turned off,

do not have lights on as you start or turn off your vehicle.

• Using the wrong bulbs may cause a malfunction, use only specified PIAA bulbs.

• When changing bulbs or lenses follow the lamp assembly/disassembly diagram.

• Leave at least 1/8” clearance between the lamps and the front spoiler,

as the heat may damage the spoiler.

1 2 3 4 5 6 7 8

Shrnutí obsahu

Strany 1 - Installation Instructions

Thank you very much for purchasing PIAA product.Please read this entire manual before installation and use of this product.Installation Instructions21

Strany 2 - CONTENTS

CONTENTSTOOLSTwo (2) PIAA 2100X lamps One (1) piece of VelcroHex wrenchTwo (2) adhesive padsOne (1) PIAA one touch connectorOne (1) PIAA preassembl

Strany 3 - INSTALLATION

LAMPINSTALLATION• The work site must be clean and level with enough working space to complete the job without distractions.• When mounting the lamps m

Strany 4

HARNESSINSTALLATION1. Before connecting any wires, the negative (-) battery terminal should be disconnected. When connecting the wires on the harness

Strany 5

WIRINGDIAGRAM4.

Strany 6 - FOG LIGHT

DRIVING LIGHTAIMINGTypically, driving lights are mounted above the front bumper about 14-30 inches from the ground to provide extra high beam illumina

Strany 7 - LAMP SERVICE

LAMP SERVICEBulb RetainerPush down and out to release.Slide insulator over connector.When service is complete reverse steps to assemble lamp.Make sure

Strany 8 - WARRANTY

With the exception of bulbs, PIAA Corporation, USA ("PIAA") warrants its products to be free from defects in workmanship and materials under

Komentáře k této Příručce

Žádné komentáře

Piaa 2100 Series Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Osvětlení Piaa 2100 Series. PIAA 2100 Series User Manual Uživatelská příručka

Shrnutí obsahu

Komentáře k této Příručce

Související produkty a manuály pro Osvětlení Piaa 2100 Series