Piaa RS400 H.I.D. Shock Lamp Uživatelský manuál stáhnout pdf

Shock Lamp RS400 H.I.D.

Installation Instructions

Thank you very much for purchasing this PIAA product.

Please read the entire manual before installation and use of this product.

FOR INSTALLERS

Please give this installation manual to customer after installing.

When installing two lamps on the vehicle, it is necessary to purchase another relay harness

(PN 34035). One harness is required for each lamp.

• Lighting laws vary from state to state.

Check your local laws before use.

• The lamps get very hot when they have been in use.

Do not touch them as they may cause burns.

• After the lights have been on, do not place them near ammable objects.

• Do not splash water directly on the hot lamps, as this may cause cracking of the lens due

to dramatic change in temperature.

• To avoid potential damage to your eyes, do not look directly into the lamp.

• This product is designed for 12V automotive electrical systems only.

• Using this light system while the engine is not running will drain the battery.

• Do not repeatedly turn the light system on and o as it will shorten the life of the system.

• To avoid potential damage to your lights, make sure your lights are turned on prior to

starting or shutting o your vehicle.

• Using the wrong bulbs may cause a malfunction. Use only specied PIAA bulbs.

• When changing bulbs or lenses follow the lamp assembly/disassembly diagram.

WARNING

1 2 3 4 5 6 ... 11 12

Shrnutí obsahu

Strany 1 - Shock Lamp RS400 H.I.D

Shock Lamp RS400 H.I.D.Installation InstructionsThank you very much for purchasing this PIAA product.Please read the entire manual before installation

Strany 2

10NOTES

Strany 3 - CONTENTS

Strany 4 - LAMP INSTALLATION

PIAA CORPORATION, USA3004 NE 181st AvenuePortland, Oregon 97230Telephone: 503.489.6666Fax: 503.489.6600Web: www.piaa.comPIAA LIMITED WARRANTYWith the

Strany 5 - HARNESS INSTALLATION

• When activated, this system operates at extremely high voltage (20,000V). DO NOT turn on the switch when holding the cord that connects the ballast

Strany 6 - WIRING DIAGRAM

CONTENTS* Make sure that all parts are in the package. If something is missing, please contact the store where you purchased the product.Philips-hea

Strany 7 - DRIVING LIGHT AIMING

4• When using a commercially supplied lamp bracket, before removing the bolt that is already installed on the car body, make sure that it is safe to

Strany 8 - DISASSEMBLY

When connecting the wires on the harness, follow the wiring diagram and the se-quence below.1. Before connecting any wires, disconnect the negative (

Strany 9

6WIRING DIAGRAM

Strany 10

7DRIVING LIGHT AIMINGTypically, driving lights are mounted above the front bumper about 14-30 inches from the ground to provide extra high beam illumi

Strany 11

8DISASSEMBLY1. Pry white cover o lamp at the arrow location on the black housing.2. Unscrew the black (BK) frame.3. Remove L&R&BK frame u

Strany 12 - PIAA LIMITED WARRANTY

95. L&R&BK frame unit...6. Unscrew 6 screws on the L&R&BK frame unit and take L&R unit away from the B&K frame. (Note: No